Recent Searches
    Series ()
      Models ()
        Keywords

          RGB Digital Fibreoptic SensorsCZ-V20 series

          CZ-V22A

          Amplifier Unit, Expansion Unit, NPN

          SPECIFICATIONS

          Select Language

          Model

          CZ-V22A*1

          Output

          NPN output

          Main unit/Expansion unit

          Expansion unit

          Response time

          200 µs (HIGH SPEED) /1 ms (FINE) /4 ms (TURBO) /8 ms (SUPER)

          Control output

          NPN open-collector x 4 channels, 40 VDC max., Up to 100 mA for one output, Up to 200 mA in total of 4 outputs, Residual voltage: 1.0 V max.*2

          Protection circuit

          Reverse-polarity protection, overcurrent protection, surge absorber

          External tuning input, external bank switch input (C/C + I-mode), external shift input (super I-mode)

          Input time: 20 ms min.

          Timer function

          Timer OFF/OFF-delay/ON-delay/One-shot, Timer time: 1 to 1000 ms adjustable (for each bank respectively)

          Unit expansion

          Up to 3 units (4 units total including the main unit)

          Number of interference prevention units

          0 for HIGH SPEED; 2 for FINE/TURBO/SUPER

          Rating

          Power voltage

          24 VDC, Ripple (P-P) 10 % or less

          Power consumption

          Normal mode: 1.5 W (62.5 mA or less), Eco-mode: 1 W (42.0 mA or less)

          Environmental resistance

          Ambient temperature

          -10 to +55 °C (No freezing)*3

          Vibration resistance

          10 to 55 Hz, Double amplitude 1.5 mm, 2 hours in each of the X, Y, and Z axis

          Material

          Housing, cover: Polycarbonate

          Accessories

          End Unit × 2

          Weight

          Approx. 100 g

          *1 The expansion unit of the FS-V20 Series cannot be connected to the main unit of the CZ-V20 Series. To connect the FS and CZ Series units, connect the expansion unit of the CZ-V20 Series to
          the main unit of the FS-V20 Series.
          To connect two or more expansion units, connect the CZ-V20 Series units on the right of the FS-V20 Series units.
          *2 20 mA max. when several units are connected.
          *3 When several units are connected, the acceptable ambient temperature varies depending on the conditions given below. To connect several units, be sure to mount them to a DIN rail and to limit the output
          current to a maximum of 20 mA.
          When 1 or 2 units are connected: -10 to +50 °C
          When 3 units are connected: -10 to +45 °C

          • For Beginners Sensor Basics Understanding fundamental - Introduction Guide to Sensors
          • General Catalogue Request
          • Trade Shows and Exhibitions
          • eNews Subscribe

          Sensors